Human Electric Trike Thesis

Design of an electrically assisted human powered trike

Fabrication Status

Posted by Bob Dold on Saturday, September 30, 2006 3:36 PM

Fabrication of components is progressing ahead of schedule, the spreadsheet below shows the status of the parts that have been completed and those that are left to build:

On Friday I went into the shop and cut most of the tubing to length for the frame rails and rear swing arm. I also did the the bonding of the lower a-arm assemblies using the Loctite 680 as the adhesive. Bond prep consisted of  cleaning with Scotchbrite and then wiping with Acetone and then applying the green adhesive. The 680 took about 15 minutes to set and seemed to completely cure in about 24 hours. The pictures below show the lower a-arm and the sides of the swingarms bonded together:


Leave a Reply

Fill in your details below or click an icon to log in: Logo

You are commenting using your account. Log Out /  Change )

Google+ photo

You are commenting using your Google+ account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )


Connecting to %s

%d bloggers like this: