Human Electric Trike Thesis

Design of an electrically assisted human powered trike

7-18 Update

Posted by Bob Dold on Tuesday, July 18, 2006 3:06 PM

Was on vacation last week so not a lot was accomplished, after going through and pricing out some of the frame components I decided it needed to be redesigned for easier and less costly fabrication. My new concept is to use 3/4″ aluminum plate at the tube junctions that will be joined to the tubes by 1″ u channel, rivets and epoxy. Round tubes will connect the crossmembers at the front and rear to tie the frame sections together.

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s

 
%d bloggers like this: